CUTTING HEIGHT
1. The mower must be turned o when adjusting the cutting height.
Never adjust the cutting height with the engine running.
2. The cutting height is adjusted by turning the lever. Turn the lever
clockwise to lower the knife down and counterclockwise to raise
it.
3. Make sure that the mower is always kept horizontal by adjusting
the handle.
STARTING THE ENGINE
Observe all safety precautions: Keep hands and feet away from the cutting blades and other
moving parts. Ensure that bystanders are at a safe distance from the machine.
1.Make sure that there is space between the blades and ground / grass.
2. Choose an area free from loose objects that can be thrown around.
3. Make sure the machine is braked and the cutting height set in the desired position.
4. Turn the fuel valve. Turn the key to “ON” position.
5. Turn the throttle. Insert the key in the ignition and press the “ON” position then turn the key
to “START”.
6. When the engine is cold, push up the throttle to start the shock (Picture 3).
7. If the engine does not start, press the throttle to about 1/4 and try again.
8. Always set the throttle to maximum eect when mowing or trimming grass.
6. Always warm up the engine at idle before use, in order to give the engine a normal working
speed of up to 3600 RPM.
NOTE! Always turn the fuel valve o as soon as the engine is o. Make sure the “ON /
OFF” switch is in the “OFF” position after each use.
KÖRNING OCH HASTIGHET
WARNING!
If the gas is changed to increase the speed above the given recommendations,
the insurance may get invalid. Cut eectiveness will decrease, fuel consump-
tion will rise and large vibration can occur causing danger to the user and the
equipment.
throttle - full gas
”The lever must be up additio-
nal 1-2cm” Choke mode.
The throttle in the o mode
PICTURE 1
PICTURE 2
PICTURE 3
To Next Page
