Kelso KCM65 - Product Introduction; Product Symbols Explained; Intended Use of the Mixer; Power Supply Requirements

4
INTENDED USE
The power tool is designed for mixing of dry or wet materials
suchasconcrete,mortar,plaster,cementrender,sandandne
aggregate. Do not mix food. The power tool is not designed
forprocessingfood.Donotusethistooltomixammableor
explosive materials. Fire or explosion can cause severe burns or
death.
The manufacturer accepts no liability for possible damage
or accidents caused by using or operating the device
inappropriately or incorrectly.
The manufacturer is not liable for damages that the product
causes if:
• the product is incorrectly repaired.
• the product is repaired with parts that are not from the
manufacturer or not approved by the manufacturer.
• the product has an accessory that is not from the manufacturer
or not approved by the manufacturer.
POWER SUPPLY
The product shall only be connected to the voltage stated on the
type plate and it only works with single-phase AC voltage. It is
provided with double protective insulation in accordance to AS/
NZS 3000:2018 Standards Australian and thus, it may be also
connected to sockets without ground cable.
Doonlyuseextensioncableswithinsucientcrosssection.A
cross section that is too small may lead to excessive loss of power
and overheating of the tool and the cable. Connections must be
made with protected material suitable for outdoor use.
Ensure the power outlet is protected by residual current device
(RCD) with a rated residual current of 30mA or less before
connecting the power plug of the power tool.
SYMBOLS ON THE PRODUCT
Wear protective clothing!
Risk of injury. Do not touch moving parts.
CAUTION: Electrical cables are a trip hazard.
Do not expose electrical components to water.
Do not throw in the household waste!
Electromagnetic Compatibility (EMC) tested to
comply with electrical regulatory standards.
DANGER! CAN CAUSE SKIN BURNS & EYE
DAMAGE: Avoid contact with the eyes and skin
from both wet and dry cement.
Read the manual carefully and make sure that you
understand the instructions before you use the
product.
WARNING: Work with concentration and care.
Keep your workplace clean and avoid hazardous
situations. This product could cause serious injury
to the operator or others.
Risk of electric shock
Wear eye protection!
Wear ear protection!
Wear a dust mask!
Wear protective gloves!
Wear protective boots!
INTRODUCTION