Kelso KCM65 - Troubleshooting Guide

16
TROUBLESHOOTING
Problem Possible Cause Solution
The power tool will not
start
Power cord not plugged in Ensure all electrical cords are connected to the mains power.
Power switch not in the on
position
Ensure all switches of the power tool and mains power are on.
Wrong power source
Ensure power tool is connected to the correct power source as indicated on the
name plate.
Circuitbreakershuto
Check and reset circuit breaker. If tripped: inspect power cords for signs of damage.
Electrical switch or motor is damaged.
Electrical switch is damaged Repairpowertoolbyaqualiedelectricianatauthorisedservicecentre.
Motor is damaged Repairpowertoolbyaqualiedelectricianatauthorisedservicecentre.
The power tool
automatically switched
o
Power cord not plugged in Ensure all electrical cords are connected to the mains power.
Motor is overheated
This is normal: temperature-dependent overload protection has engaged. Wait for
the power tool to cool down.
Circuit breaker has been
engaged
Check circuit and switches are active. Then restart.
Power tool does not
reach full power
Mixing volume is too large Reduce the amount of material in the mixing bowl.
Extension cord not suitable
for operation with this
product
Use a heavy duty extension cord, <25m.
Power source voltage is
too low
Connect to another power source.
Motor is worn Repair / replace the worn motor.
The mixing bowl does
not rotate when empty
Motor is not running Refer problem: The power tool will not start.
Gears are not engaged
Turnopowertool.Performvisualinspectionofpiniongearandcorrectalignment.
If gear is damaged replace part.
V-Belt is slipping
Turnopowertool.ReferHOWTODOACHECKOFTHEV-BELT.
If belt is damaged replace part.
Pinion gear not turning
Check connection between pinion shaft and upper pulley.
Check connection between pinion gear head and shaft.