To Next PageTo Next PageHow to fix a Kelvinator Air Conditioner that won't start?
If your Kelvinator Air Conditioner doesn't start, there are a couple of things to check: First, ensure the air conditioner plug is fully pushed into the outlet and that the power is switched on. Second, inspect your house's fuse or circuit breaker box, and replace the fuse or reset the breaker if necessary.
Why is my Kelvinator KWH26CRB not cooling properly?
If your Kelvinator Air Conditioner isn't cooling as expected, several factors could be at play. A common cause is a dirty air filter, which should be cleaned at least every two weeks. Also, remember that after turning on the air conditioner, you need to allow time for the room to cool down. Ensure cold air isn't escaping through open furnace floor registers or cold air returns. Finally, check that curtains, blinds, or furniture aren't blocking the front of the unit, restricting airflow.
What to do if my Kelvinator KWH26CRB fails due to a power outage?
If a power failure occurs, switch off and disconnect / unplug the power cord of your Kelvinator Air Conditioner. When power is restored, reconnect (plug in) the power cord, switch on the power and wait 3 minutes to restart the air conditioner to prevent tripping of the compressor overload.
General| Cooling Capacity | 2.6 kW |
|---|---|
| Refrigerant | R32 |
| Power Supply | 220-240V, 50Hz |
| Air Flow Volume | 550 m³/h |
| Noise Level (Indoor Unit) | 39 dB(A) |
| Net Weight (Indoor Unit) | 8 kg |
| Type | Split System |
| Operating Temperature Range (Cooling) | 18°C to 43°C |
Details actions to avoid for safety and to prevent equipment damage.
Outlines essential practices for safe operation and unit care.
Lists and illustrates the main components of the air conditioner unit.
Explains power cord conductor colors and grounding requirements for safety.
Describes the electronic control keypad and its functions for different models.
Explains how to adjust the vent for optimal air circulation and stale air discharge.
Explains the operation of POWER, MODE, TEMP, FAN, SWING, and TIMER buttons.
Details the DRY, COOLING, HEATING, AUTO, and SLEEP modes and their settings.
Covers remote control operation, buttons, battery replacement, and troubleshooting indicators.
Provides guidelines for choosing an optimal and safe installation location.
Details steps for preparing the wall opening and installing the housing.
Explains how to safely slide the main unit into its installed housing.
Provides a detailed sequence for removing panels, frame, and installing the unit.
Describes common noises and water collection during normal operation.
Lists possible causes and solutions for the unit failing to start.
Addresses issues related to restricted airflow, dirty filters, or escaping cold air.
Explains causes and remedies for the cooling coils icing up.
Provides physical dimensions for different air conditioner models.
Details minimum conductor cross-sectional area based on appliance current.
Recommends AWG wire sizes for various appliance amperage ratings.
