To Next PageTo Next PageHow to fix a Kelvinator Air Conditioner that won't start?
If your Kelvinator Air Conditioner doesn't start, there are a couple of things to check: First, ensure the air conditioner plug is fully pushed into the outlet and that the power is switched on. Second, inspect your house's fuse or circuit breaker box, and replace the fuse or reset the breaker if necessary.
Why is my Kelvinator KWH39HRB not cooling properly?
If your Kelvinator Air Conditioner isn't cooling as expected, several factors could be at play. A common cause is a dirty air filter, which should be cleaned at least every two weeks. Also, remember that after turning on the air conditioner, you need to allow time for the room to cool down. Ensure cold air isn't escaping through open furnace floor registers or cold air returns. Finally, check that curtains, blinds, or furniture aren't blocking the front of the unit, restricting airflow.
What to do if my Kelvinator Air Conditioner fails due to a power outage?
If a power failure occurs, switch off and disconnect / unplug the power cord of your Kelvinator Air Conditioner. When power is restored, reconnect (plug in) the power cord, switch on the power and wait 3 minutes to restart the air conditioner to prevent tripping of the compressor overload.
General| Cooling Capacity | 3.5 kW |
|---|---|
| Power Supply | 220-240V, 50Hz |
| Refrigerant | R410A |
| Air Flow Volume | 600 m³/h |
| Noise Level (Outdoor) | 52 dB(A) |
| Type | Split System |
| Energy Efficiency Ratio (EER) | 3.21 |
| Operating Temperature (Cooling) | 18-43 °C |
Explains safety symbols and specific warning instructions.
Precautions for safe operation, cleaning, and handling.
Advice on proper and safe air conditioner usage.
Instructions for cleaning the air conditioner and its parts.
Identifies main air conditioner parts with a diagram.
Details control panel functions and vent lever operation.
Explains selection of operating modes and fan speeds.
Instructions for temperature setting, swing, and sleep modes.
Lists and explains remote control buttons like TEMP, POWER, MODE.
Detailed instructions for using remote control features.
Guidance on selecting an installation location and preparing the wall.
Steps for installing the housing and mounting the unit into the wall.
Step-by-step guide for assembling and installing unit components.
Describes expected sounds and water behavior during normal operation.
Solutions for common issues like unit not starting or not cooling.
Provides physical dimensions and electrical requirements.
Outlines warranty terms, conditions, and exclusions.
