To Next PageTo Next PageHow to fix a Kelvinator KWH26HRB that won't start?
If your Kelvinator Air Conditioner doesn't start, there are a couple of things to check: First, ensure the air conditioner plug is fully pushed into the outlet and that the power is switched on. Second, inspect your house's fuse or circuit breaker box, and replace the fuse or reset the breaker if necessary.
Why is my Kelvinator KWH26HRB Air Conditioner not cooling properly?
If your Kelvinator Air Conditioner isn't cooling as expected, several factors could be at play. A common cause is a dirty air filter, which should be cleaned at least every two weeks. Also, remember that after turning on the air conditioner, you need to allow time for the room to cool down. Ensure cold air isn't escaping through open furnace floor registers or cold air returns. Finally, check that curtains, blinds, or furniture aren't blocking the front of the unit, restricting airflow.
What to do if my Kelvinator KWH26HRB Air Conditioner fails due to a power outage?
If a power failure occurs, switch off and disconnect / unplug the power cord of your Kelvinator Air Conditioner. When power is restored, reconnect (plug in) the power cord, switch on the power and wait 3 minutes to restart the air conditioner to prevent tripping of the compressor overload.
General| Brand | Kelvinator |
|---|---|
| Model | KWH26HRB |
| Category | Air Conditioner |
| Language | English |
Explains the meaning of WARNING and CAUTION symbols used in the manual.
Details critical actions like plugging in properly, earthing, and unplugging when issues arise.
Lists actions to avoid, such as modifying cords or operating with wet hands.
Covers precautions for filter removal, cleaning, and room ventilation.
Lists restrictions on using the appliance for special purposes or with specific items.
Specifies acceptable outdoor and indoor temperatures for cooling.
Specifies acceptable outdoor and indoor temperatures for heating.
Identifies and labels all major parts of the air conditioner unit.
Explains the control keypad layout and vent control lever functionality.
Details how to select operating modes and fan speeds.
Explains temperature adjustment, swing, and sleep mode functions.
Describes the operation of DRY, COOLING, HEAT, and AUTO modes.
Explains the specific operations and effects of the SLEEP mode.
Explains error codes indicated on the display.
Lists and describes the functions of the remote control buttons.
Details remote control range, signal reception, and operating procedures.
Covers adjusting airflow and cleaning the air filter.
Details the procedure for setting up drainage for cooling-only models.
Provides guidance on choosing the best placement for the unit.
Details steps for preparing the wall hole and installing the housing.
Explains how to slide and secure the unit into the installed housing.
Outlines the sequential process for installing the unit components.
Describes expected noises and behaviors during normal operation.
Lists common issues and their troubleshooting steps.
Provides physical dimensions for different model capacities.
Suggests minimum wire sizes based on appliance current.
Outlines the terms, limitations, and requirements of the product warranty.
Provides contact information for service and spare parts.
