5
5. Emptying of the Dust Collection Container
You have to check the liquid level of the dust collection container regularly. The container has to
be emptied if it is brimmed. The timeperiod between two emptying processes are depending on
the type and the duration of the welding work. We recommend to check the liquid level inside the
container before resp. after using of the filter unit. To avoid any contact with the welding smoke
/dusts you should wear protection gloves and breathing masks during emptying of the container.
• Switch the filter unit off and disconnect it from the power supply.
• Open both catches at the lower side of the unit.
• Remove the upper part of the unit with the filter and the turbine inside the dust collection
container.
Make sure that you do not damage the sealing around the unit.
• Dispose the welding smoke / dust which is inside of the dust collection container according
to legal regulations.
• Remount the cleaned collection container to the unit and connect the power supply to the unit.
The unit is ready for operation now.
Please keep in mind: The welding smoke / dusts have to be stored and removed according to
the regulations of the laws for recycling and wastes. Due to different
compositions of the welding smoke/dusts you may have to ask for the
storage and waste codes at your local recycling company.
To Next Page
Loading...