What to do if welding smoke is escaping through the outlet opening of Kemper Dusty?
If welding smoke escapes through the outlet opening of your Kemper Scrubber, it could be due to an unappropriate sealing between the filter cartridge and filter housing. Try refastening the mounting screws of the filter cartridge. Alternatively, there might be holes in the filter cartridge, in which case you should replace it.
Why is the extraction capacity of my Kemper Dusty Scrubber too low?
If the extraction capacity of your Kemper Scrubber is too low, the suction hose or capturing device may be clogged. Clean the suction hose or capturing device. Alternatively, the filter cartridge might be saturated and needs cleaning.
How to fix a Kemper Dusty Scrubber filter unit that will not switch on?
If your Kemper Scrubber filter unit cannot be switched on, ensure it is properly connected to the power supply. Also, check that the power cable is correctly plugged into the socket. If these steps don't resolve the issue, the motor protection might be faulty, requiring a replacement of the power cable. Finally, replace the fuse in the fuse carrier at the inlet connector for non-heating apparatus.
Essential safety guidelines for safe operation and maintenance of the KEMPER Dusty unit.
The main switch to turn the unit on and off.
Monitors filter saturation, signaling when cleaning is necessary.
Allows user to control the extraction performance level.
Solutions for issues where the filter unit does not switch on.
Troubleshooting steps for problems with the suction power adjustment knob.
Guidance to resolve issues causing a decrease in extraction capacity.
Solutions for welding smoke escaping from the unit's outlet.
To Next Page
General