Kemppi SA 35 Quick Start Guide

2 3
© Kemppi Oy 2020
SA 35, SA 60B, SA 60i, XA 47
2002
INTRODUCTION
The auto-darkening lter (ADF) is an electronic lter cassette
that darkens from light state to a pre-selected dark shade
when the welding arc is ignited. Select the appropriate shade
before you start welding. This product is designed to help
protect your eyes from harmful radiation including visible
light, ultra-violet radiation (UV) and infra-red radiation (IR)
resulting from certain welding processes. ADF oers perma-
nent protection against UV/IR rays, heat and sparks in any
state from the light to the dark.
SAFETY
• When tted to a suitable face shield that meets the
necessary and local safety standards, this ADF is
suitable for welding, grinding, cutting, spraying and
arc gouging. It is not suitable for laser welding and
oxyacetylene welding/cutting processes.
• The ADF does not protect against explosive devices or
corrosive liquids.
• Always use the protective lens on the ADF. Replace the
protective lens when it becomes dirty/discolored/worn/
cracked/scratched/pitted.
• Avoid heavy knocks on the ADF as it may break.
• If the ADF does not darken when the arc ignites,
stop welding immediately. Inspect the ADF, check the
batteries and change if necessary. If this does not help,
contact a Kemppi representative or your supervisor.

Kemppi SA 35 Specifications

General

Brand	Kemppi
Model	SA 35
Category	Protection Device
Language	English