23. Make sure cord is located so that it will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
24. If the cables need to be run through walls with sharp edges, for example
metal sheets, use tubes or cable ducts to prevent damage to the cables.
Lay electrical cables in such a way that it is not possible to stumble over
them, thereby preventing damage.
25. Do not operate or disassemble charger if it has received a sharp blow,
been dropped, or otherwise damaged in any way; take it to a qualified
serviceman. Incorrect use or reassembly may result in a risk of electric
shock or fire.
26. Keep the charger away from children. Children do not understand or
perceive possible risks when handling electrical devices.
27. This appliance is not intended for use by persons (including children) with
reduced physical, sensory or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or instruction
concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the
charger.
28. Do not charge battery packs when temperature is below 10℃ (50°F) or
above 40℃ (104°F).
29. Do not attempt to use the charger as a step-up transformer, an engine
generator or DC power receptacle.
30. When the appliance is not in use and cleaning, unplug the appliance from
the outlet. before
31. Do not operate charger with damaged cord or plug.
32. Only operate the charger if all cables and the casing are intact.
33. Never operate the device if it has been dropped or damaged in any other
way. For inspection and repair, take it to a qualified electrician.
34. This charger belongs to type Y attachment, if the supply cord is damaged,
it must be replaced by the manufacture, its service agent or similarly
qualified persons in order to avoid a hazard.
35. All maintenance work must be conducted by qualified electricians.
36. Never disassemble the device, incorrect assembly may cause electric
shock or fire.
37. For the protection class is IP20. The product shall not be used outside the
room, where it is the rainy and snowy.
38. In the course of charging, the charger should be put at a level place and
shouldnot be tilted or reversely placed.
39. As the casing can generate heat during charging. it is prohibited to cover
the vent of casing.
40. The maintenance work for the charger should be done by the
professionals.
41. When electrified, the battery clamps should not be contacted with each
other.
To Next Page
Loading...
