What does "Lift Lid" mean on my Kendro Heraeus Multifuge 1 S?
If the message "Lift Lid" appears in the display of your Kendro Laboratory Equipment, it means that the lid has not been unlocked after release. Avoid placing objects onto the centrifuge lid and lift the lid slightly.
What to do if the lid of my Kendro Laboratory Equipment won't open?
If you are unable to open the lid of your Kendro Laboratory Equipment, first ensure that the main power connection is working and the instrument is switched on, verifying that the display is lit. Next, press the lid down firmly in the middle of the front section while simultaneously pressing the "open lid" key. If the lid still won't open, you can use the emergency lid release.
What does "bAl" mean on my Kendro Heraeus Multifuge 1 S Laboratory Equipment display and how to fix it?
If the message "bAl" appears on the display of your Kendro Laboratory Equipment, it indicates that the imbalance switch has been activated. To resolve this, open the instrument by pressing the "open lid" key. Check that the rotor is properly loaded and inspect for any broken tubes or damage to the rotor that may have triggered the switch. Also, ensure that the trunnions of the swinging bucket rotor are adequately lubricated.
How to fix dark displays on my Kendro Laboratory Equipment?
If the displays on your Kendro Laboratory Equipment remain dark, it indicates a mains voltage disconnection. First, verify that the mains plug is turned on and check the main power connection. If the main connection is confirmed to be working, it may indicate a more complex issue.
Why does my Kendro Laboratory Equipment display "OPEN" when the lid is closed?
If the display shows "OPEN" even when the lid is closed on your Kendro Laboratory Equipment, it indicates that the lid is not properly closed. Open the lid and repeat the locking procedure.
Why do the displays on my Kendro Laboratory Equipment fail briefly?
If the displays on your Kendro Laboratory Equipment fail briefly, it is because the main connection was briefly interrupted. Turn off the main switch, check whether the mains power cord is connected properly, and then restart the centrifuge.
What does error E-28 mean on my Kendro Heraeus Multifuge 1 S?
If error code E-28 appears on your Kendro Laboratory Equipment, it indicates that the motor is running in the wrong rotational direction. Switch the instrument off and on again.
What does error E-30 mean on my Kendro Heraeus Multifuge 1 S Laboratory Equipment?
If error code E-30 appears on your Kendro Laboratory Equipment, it indicates that the control voltage breaks down. Switch the instrument off and on again.
What does error E-33 mean on my Kendro Heraeus Multifuge 1 S?
If error code E-33 appears on your Kendro Laboratory Equipment, it indicates overpressure in the refrigeration system. Turn the instrument off and pull the main plug. Check and clean the ventilation slots if necessary. After about 60 minutes, you can restart the instrument, ensuring you observe the maximum permissible environmental temperature!
What does error E-31 mean on my Kendro Laboratory Equipment?
If error code E-31 appears on your Kendro Laboratory Equipment, it indicates overtemperature in the motor. Turn the instrument off and unplug the mains power cord. Check and clean the ventilation slots if necessary. After about 60 minutes, you can restart the instrument, ensuring you observe the maximum permissible environmental temperature.
General| Max Speed | 15, 000 RPM |
|---|---|
| Maximum Speed | 15, 000 RPM |
| Capacity | 4 x 250 ml |
| Temperature Range | Not applicable |
| Timer | 0-99 minutes |
| Noise Level | <65 dB |
| Power Requirements | 230 V, 50/60 Hz |
To Next Page