Kenmore 111.7330 Series

Questions and Answers

C
Christopher SalazarAug 9, 2025
Why is my Kenmore 111.7330 Refrigerator and Freezer not cooling?
- C
  Courtney WilliamsAug 9, 2025
  If your Kenmore Refrigerator and Freezer are not cooling, ensure the power cord is properly plugged into a grounded 3-prong outlet. If the refrigerator is in demo mode, this disables cooling to save energy; refer to the Setting the Controls section to disable it. Also, during the defrost cycle, temperatures may rise slightly; wait 30 minutes after the cycle. If recently installed or relocated, allow up to 24 hours for temperature stabilization and ensure it stood upright for 24 hours after relocation.
J
John BowersAug 17, 2025
Why is my Kenmore 111.7330 Refrigerator cooling system running too much?
- S
  Stephanie StevensAug 17, 2025
  Several factors can cause your Kenmore Refrigerator's cooling system to run excessively. Modern refrigerators often run longer due to energy-efficient technology. If recently plugged in, allow up to 24 hours to cool completely. Frequent door openings or adding warm food increases compressor run time; organize food for quick access and ensure doors are fully closed. High ambient temperatures also extend run times; avoid operating above 110°F. Finally, a clogged condenser can cause this issue; clean the condenser cover and vents with a vacuum.
A
amytapiaAug 25, 2025
How to prevent interior moisture buildup in my Kenmore Refrigerator?
- K
  Kristen CamposAug 25, 2025
  If you notice moisture buildup inside your Kenmore Refrigerator, it could be due to several reasons. Frequent or prolonged door openings allow humid air to enter. Ensure doors are closing correctly. Humid weather can also introduce moisture; maintaining reasonable humidity in your home helps. The defrost cycle can cause temporary condensation. Also, ensure food is properly packaged in sealed containers to prevent moisture accumulation.
K
Kyle ButlerAug 31, 2025
What to do if my Kenmore 111.7330 or Freezer section is too warm?
- R
  Ryan MitchellAug 31, 2025
  If your Kenmore Refrigerator or Freezer is too warm, it might need up to 24 hours to reach the desired temperature after installation. Frequent door openings or adding warm food can raise the temperature. Make sure the refrigerator isn't in a hot location, and the temperature should not exceed 110F. Ensure the doors are closing correctly, and the temperature control is set appropriately. During the defrost cycle, the temperature may increase temporarily; wait 30 minutes after the cycle.

Summary

Kenmore Limited Warranty

One Year on Appliance

Important Safety Instructions

Basic Safety Precautions

General safety messages and hazard signal word definitions for safe appliance operation.

Risk of Child Entrapment

Dangers associated with abandoned refrigerators and steps to prevent child entrapment.

Refrigerator Installation

Unpacking Your Refrigerator

Installation Requirements

Removing and Replacing Refrigerator Doors

How to Remove the Freezer Drawer

Refrigerator Leveling & Door Adjustment

Using Your Refrigerator

Temperature Control

Control Panel Overview

Icemaker Operation

Instructions for turning the icemaker on/off, troubleshooting, and ice bin management.

Connecting the Water Line

Water Filter

Care and Cleaning

Troubleshooting Guide

Cooling System Issues

Diagnosing and resolving problems related to refrigerator and freezer cooling performance.

Ice and Water System Issues

Troubleshooting common problems with icemakers, water dispensers, and ice production.

Noise Issues

Identifying and resolving unusual noises like clicking, rattling, and whooshing.

Parts and Features Troubleshooting

Resolving issues with doors, leveling, lights, odors, and general compartment problems.