/
Fig. 4
Fig 5
1, Place thread on spool pin as shown,
with the threading coming from the
back of the spool (Fig. 1.-a). Draw
thread through the rear thread guide
(Fig. 1.b, !-c)0 Pass thread through top
thread guide (Fig. led),
2. Holding the spool with the right hand.
pull the thread through tile tension
discs. The spring wire loop should be
pulled up until the thread passes
beyond the beak bf 1he hook. Fig. 2.
3. After the thread has slipped into the
hook. allow the spring wire to return to
position by releasing the thread spool.
Fig. 3.
4. Cor!tinue threading through the front
thread guide, hook thread into take up
lever and down through path _shown in
Fig, 4 and 5,
5. Always thread needle in direction as
shewn iT_Fig. 5,
To Next Page
Loading...
