To Next PageTo Next PageHow to prevent premature tank failure in Kenmore 153.331572?
To prevent premature tank failure (leakage) due to thermal expansion, a properly sized thermal expansion tank should be installed on all closed systems. This will control the harmful effects of thermal expansion.
General| Brand | Kenmore |
|---|---|
| Model Number | 153.331572 |
| Energy Source | Electric |
| Voltage | 240 V |
| Warranty | 6 years |
| Fuel Type | Electric |
| Type | Electric |
| Wattage | 4500W |
| Recovery Rate | 21 gallons per hour |
Essential safety instructions and warnings for the operation of the water heater.
Details on fire and explosion risks, storage of flammables, and gas leak response.
Information on severe burn risks from hot water and methods to prevent scald injuries.
Warnings about carbon monoxide hazards and necessary ventilation and detection measures.
Details of the 12-year limited warranty for parts and the 1-year labor warranty.
How to obtain warranty service, including contact numbers and procedures.
Information on optional extended service plans and their benefits.
Ensuring installation adheres to national, state, and local plumbing and gas codes.
Guidelines for safely moving and installing the water heater, including weight warnings.
List of materials Sears offers or recommends for installation, like expansion tanks and kits.
List of basic tools and additional tools required for sweat soldering plumbing.
Diagram identifying major components and parts of the gas water heater.
A comprehensive checklist to verify all installation requirements are met.
Critical requirements for combustion air supply and proper ventilation.
Key considerations for water system piping and gas supply installation.
Step-by-step process for safely disconnecting and removing the old water heater.
Guidelines for choosing an appropriate and safe location for the water heater.
Instructions for applying insulation blankets and maintaining required clearances.
Detailed instructions for gas supply line connection, shut-off valves, and leak testing.
Ensuring adequate fresh air for combustion and ventilation in confined and unconfined spaces.
Guidelines for installing vent pipes, draft hoods, and connecting to chimneys.
Instructions for installing water supply and discharge piping, including safety notes.
Managing thermal expansion and properly installing the temperature-pressure relief valve.
Step-by-step guide for safely lighting the pilot light using the piezo igniter.
Procedures to verify proper draft and inspect burner flame appearance for correct operation.
Instructions on setting and adjusting the water temperature for optimal performance and safety.
Annual maintenance for tank sediment removal and vent system inspection.
Procedures for inspecting and cleaning the burner for efficient operation.
Checking the anode rod for corrosion and testing the temperature-pressure relief valve.
Steps for draining the tank, flushing sediment, and general service considerations.
Information on ordering replacement parts and cleaning the base-ring filter.
Instructions for removing, cleaning, and replacing burner, pilot tube, and thermocouple components.
Procedures for testing and replacing the piezoelectric igniter and gas control valve/thermostat.
Guidance on resolving initial start-up problems, thermal expansion, and condensation.
Diagnosing and correcting issues related to burner flame appearance and pilot light operation.
A step-by-step flowchart to identify and resolve pilot light issues.
A list of all available replacement parts with their corresponding part numbers and model applicability.
