INSTALLATION DIMENSIONS
]
A
[
B"
J
T
E"
1
DRAWING REPRESENTATIVE OF
A FOOD WASTE DISPOSER
IMPORTANT: PLUMB WASTE LINE TO PREVENT STAND-
ING WATER IN DISPOSER MOTOR HOUSING.
DISPOSER
NO. A B* C D E*
175.6010 113/6" 6" 6%" 5" 4"
175.6012 11%" 6" 63/8" 5" 4"
175.6011 12%" 6" 63/8" 5" 4"
175.6013 125/6" 6" 63/e' 5" 4"
175.6035 123/," 63/," 71/," 5" 4"
175.6040 123/," 67/8" 73/," 53/," 4"
175.6058 13'/6" 67/8" 73/," 53/," 4"
175.60514 12'3/,6' 63/," 8'/2" 53/," 4"
175.6109 13'/," 6"h" 8%" 53/," 4"
175.60525 151/2'' 91/2" 71/2" 5" 4"
175.60509 123/," 63/," 7'/," 5" 4"
175.60542 123/,'` 67A" 73/," 53/," 4"
NOTE: Please refer to the
dimensions which match
your disposer model number.
B" - DISTANCE FROM
BOTTOM OF SINK TO
CENTER LINE OF
DISPOSER OUTLET.
ADD 1/2"WHEN STAINLESS
STEEL SINKS ARE USED.
E° - LENGTH OF
DISCHARGE TUBE FROM -
CENTER UNE OF
DISPOSER OUTLET TO
END OF DISCHARGE
TUBE.
OKAY, LET'S START THE
INSTALLATION ONE
STEP AT A TIME.
CHECK THE PARTS AGAINST THE DRAWINGS BELOW
AND MAKE SURE EVERYTHING IS THERE. (your new
disposer may not look like the one pictured,)
SEiFSERVCE
"WRENCHETTE"
(1/4INCH HEX WRENCH)
DISCHARGE TUBE, GASKET.
METAL FLANGE AND SCREW(S)
THE MOUNTING ASSEMBLY
CONSISTING OF:
Sink sleeve
Fiber gasket
Back-up ring
Mounting ring
and 3 screws
Snap ring
•Mounting
C__ _/0_e,
mg
To Next Page
Loading...
