BUTTONHOLE MAKING ° BUILT-IN SYSTEM
PREPARATION
Carefully mark the buttonhole length on your
garment. Place the fabric with the buttonhole
marked under the buttonhole foot. Pull the
guide foot (A) all the way forward so that the
index mark (B) is aligned with the graduation
(C), with thread to rear. (Reproduction of the
identical size buttonholes is facilitated with
the aid of the graduations on the both sides
of the buttonhole guide foot. These gardua-
tions are 1/8" (left side) or 2.5mm (right side)
apart. Graduations act as reference mark.)
PROCEDURE
,
Switch the control to left. (If it has been
already at left, set it at right, sew several
stitches and switch to left again.) Step on
foot control to form first bartack and left
side of buttonhole.
2. When you reach end of left side, switch
the control to the right and complete the
buttonhole.
(#
51
To Next Page
Loading...
