PROBLEM
TOP BURNERS DO NOT
LIGHT OR DO NOT
BURN EVENLY
BURNER FLAMES VERY
LARGE OR YELLOW
SURFACE BURNERS
LIGHT BUT OVEN
DOES NOT
CONTROL SIGNALS :
AFTER ENTERING
COOKING TIME OR
START TIME : :
DISPLAY FLASHES
UNABLE TO GET THE
DISPLAY TO SHOW "SF"
FAN NOISE : :
POSSIBLE CAUSE
• Make sure electrical plug is plugged into a live power outlet,
• Burner holes on the side or around the top of burner may be clogged. Remove
burner heads and burner caps. and clean them with a sewing needle or bare wire
Make sure you do not enlarge the burner holes, Check electrode area for burned-on
food or grease
• Make sure drip pans are installed correctly.
• If range is connected to LP gas, contact the person who installed your range
or made the conversion.
• The oven gas shut-off valve may have accidentally been moved during
cleaning or moving.
To check the oven gas shut-off valve, remove the storage drawer and look
for the gas shut-off lever at the back of the range_
\ closed. PULL /
i o You forgot to enter a bake temperature or cleaning time. Press the BAKE pad
and desired temperature or the SELF CLEAN pad and desired clean time.
: i
° Power outage occurred, Reset the CLOCK. See the Using the Clock and Timer section.
° The oven control pads were not pressed properly. The BAKE and BROIL HI/LO pads
must be pressed at the same time and held for 3 seconds.
• A cooling fan may automatically turn on and off to cool internal parts_This is normal.
47
To Next Page