EasyManua.ls Logo

Kenmore 790.3690 - User Manual

Kenmore 790.3690
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
iNSTALLATiON AND SERVICE MUST BE PERFORMED BY A QUALiFiED iNSTALLER.
iMPORTANT: SAVE FOR LOCAL ELECTRICAL iNSPECTOR'S USE.
READ AND SAVE THESE iNSTRUCTiONS FOR FUTURE REFERENCE.
If the information in this manual is not followed exactly, a
fire or explosion may result causing property damage, personal injury
or death.
FOR YOUR SAFETY:
-- Do not store or use gasoline or other flammable vapors and liquids
in the vicinity of this or any other appliance.
-- WHAT TO DO IF YOU SMELL GAS:
Do not try to light any appliance.
Do not touch any electrical switch; do not use any phone in your
building.
Immediately call your gas supplier from a neighbor's phone. Follow
the gas supplier's instructions.
If you cannot reach your gas supplier, call the fire department.
-- Installation and service must be performed by a qualified installer,
service agency or the gas supplier.
Appliances Installed in the state
of Massachusetts:
This Appliance can only be installed
in the state of Massachusetts by a
Massachusetts licensed plumber or
gasfitter.
This appliance must be installed with a
three (3) foot / 36 in. long flexible gas
connector.
A"T" handle type manual gas valve
must be installed in the gas supply line
to this appliance.
IMPORTANT: Cabinet and
countertop width should match
the cutout width.
Locate Cabinet Doors
1" (2.5 cm) Min.
Cutout Opening.
" Min.
(61 cm Min.)
Grounded Junction Box or Wall Outlet Should Be Located 8" to 17" (20.3 cm
to 43.2 cm) From Right Cabinet and 2" to 4" (5.1 cm to 10.2 cm) From Floor.
Do not install the unit in the cabinet before reading next page.
35 7/8" (91.1cm) - 31 5/16" 28 5/16" (71.9cm)
36 5/8" (93cm) (79.5cm)
30_+1/16" (76.2_+0.15cm)
NOTE: Wiring diagram for these appliances are enclosed in this booklet.
Printed in United States
21 3/4" (55.2cm) Min.
22 1/8" (56.2cm) Max
24" (61cm) Min. with
backguard
36 5/8" (93cm) Max.
35 7/8" (91.1cm)
P/N 318201681 (0906) Rev. A
English - pages 1-11
Espahol - p_iginas 12-22
Wiring Diagrams - pages 23-24
Question and Answer IconNeed help?

Do you have a question about the Kenmore 790.3690 and is the answer not in the manual?

Summary

Important Notes to the Installer

Important Safety Instructions

Cabinet Construction and Preparation

Countertop Preparation

Specific steps for preparing the countertop edge to accommodate the range cooktop.

Gas Supply and Connection

Provide an Adequate Gas Supply

Requirements for natural gas or LP/Propane supply pressure and connection.

Connect the Range to the Gas Supply

Step-by-step guide for connecting the range to the gas supply line, including leak checks.

LP;Propane Gas Conversion

Electrical Requirements and Grounding

Grounding Instructions

Detailed steps and importance of proper grounding for the appliance's electrical system.

Moving the Appliance for Servicing and Cleaning

Range Installation

Standard Installation

Basic installation steps for standard cabinet configurations without special leveling devices.

Installation for Models with Leveling Device

Specific installation guidance for models equipped with a leveling device for height adjustment.

Installation for Models with Leveling Legs Only

Installation notes for models featuring only standard leveling legs, without additional devices.

Leveling the Range

Models Equipped with Leveling Device

Detailed instructions for leveling using the built-in leveling device.

Models Equipped with Leveling Legs

Instructions for leveling the range using its standard adjustable legs.

Decorative Rear Trim Installation

Check Operation

Install Burner Bases and Burner Caps

Proper placement of burner components before initial operation.

Turn on Electrical Power and Open Main Shutoff Gas Valve

Activating power and gas supply to prepare for operational checks.

Check the Igniters

Verifying that the igniter system sparks and lights the burners correctly.

Adjust the LOW Setting of Surface Burner Valves

Fine-tuning the low flame setting for surface burners to prevent extinguishing.

Oven Burner Operation and Adjustments

Checking oven burner ignition, flame quality, and air shutter adjustments.

Model and Serial Number Location

Information on where to find the appliance's model and serial number for service inquiries.

Before You Call for Service

Guidance on basic troubleshooting steps to resolve common issues before contacting support.

Anti-Tip Brackets Installation Instructions

Models Equipped with Leveling Device

Steps for installing anti-tip brackets on models with a leveling device.

Models Equipped with Leveling Legs

Steps for installing anti-tip brackets on models with standard leveling legs.

Wiring Diagram

Summary

Important Notes to the Installer

Important Safety Instructions

Cabinet Construction and Preparation

Countertop Preparation

Specific steps for preparing the countertop edge to accommodate the range cooktop.

Gas Supply and Connection

Provide an Adequate Gas Supply

Requirements for natural gas or LP/Propane supply pressure and connection.

Connect the Range to the Gas Supply

Step-by-step guide for connecting the range to the gas supply line, including leak checks.

LP;Propane Gas Conversion

Electrical Requirements and Grounding

Grounding Instructions

Detailed steps and importance of proper grounding for the appliance's electrical system.

Moving the Appliance for Servicing and Cleaning

Range Installation

Standard Installation

Basic installation steps for standard cabinet configurations without special leveling devices.

Installation for Models with Leveling Device

Specific installation guidance for models equipped with a leveling device for height adjustment.

Installation for Models with Leveling Legs Only

Installation notes for models featuring only standard leveling legs, without additional devices.

Leveling the Range

Models Equipped with Leveling Device

Detailed instructions for leveling using the built-in leveling device.

Models Equipped with Leveling Legs

Instructions for leveling the range using its standard adjustable legs.

Decorative Rear Trim Installation

Check Operation

Install Burner Bases and Burner Caps

Proper placement of burner components before initial operation.

Turn on Electrical Power and Open Main Shutoff Gas Valve

Activating power and gas supply to prepare for operational checks.

Check the Igniters

Verifying that the igniter system sparks and lights the burners correctly.

Adjust the LOW Setting of Surface Burner Valves

Fine-tuning the low flame setting for surface burners to prevent extinguishing.

Oven Burner Operation and Adjustments

Checking oven burner ignition, flame quality, and air shutter adjustments.

Model and Serial Number Location

Information on where to find the appliance's model and serial number for service inquiries.

Before You Call for Service

Guidance on basic troubleshooting steps to resolve common issues before contacting support.

Anti-Tip Brackets Installation Instructions

Models Equipped with Leveling Device

Steps for installing anti-tip brackets on models with a leveling device.

Models Equipped with Leveling Legs

Steps for installing anti-tip brackets on models with standard leveling legs.

Wiring Diagram

Kenmore 790.3690 Specifications

General IconGeneral
BrandKenmore
Model Number790.3690
Number of Burners5
Self-CleaningYes
Convection OvenYes
Power SourceElectric
Fuel TypeElectric
Product TypeRange
Width30 inches

Related product manuals