o Sewa Button
Set the Machine
St _[chselector
I
"Top thread tension Stitch length
control I [o 4 Any number
(not necessary
_,oadiusd
Z_gzag foot "i__
Darning plate
Use the darning plate for button sewing (see p, 27),
1,
2.
3.
4.
5.
Set the pattern selector at " @ "
Align the both holes of the button with the slot of the foot and place the left
hote of the button iust below the needle point,
Lower the foot and turn the pattern selector to zigzag untit the needle point
comes iust above the right hote of the button.
Sew about five stitches and raise needle.
Set the pattern setector at " @ " again and sew a few stitches to tock
thread.
To strengthen the shank, cut the
threads leawng a 8 inches tail. Bring
the needle thread down through the
hole in the button and wind it around
the shank.
Draw the thread to the underside and
knot
33
To Next Page
Loading...
Need help?
General
