Kenmore 400 series Use & Care Guide

ATTACHMENT STORAGE
This vacuum cleaner is equipped with
onboard attachment storage. The bare
floor tool is stored in the canister, See
ATTACHMENT USE TABLE on page 15.
3-IN-1 COMBINATION TOOL
The 3-in-1 combination tool can be
attached to the end of the wand and the
handle.
Slide the collar of the tool over the open
end of the wand or handle.
Use the 3-in-1 combination tool in crevice
tool mode for cleaning in tight spaces such
as furniture, between cushions, and stairs.
See ATTACHMENT USE TABLE (page 15).
Set the combination tool in dusting brush
mode by pressing the release button and
sliding the dusting brush side of the brush
tool to the end of the combination tool.
Use in dusting brush mode for cleaning
loose surfaces such as drapes. See
ATTACHMENT USE TABLE (page 15).
Dusting
Brush
Release
Button
Press the release button to remove the
brush tool. Set the combination tool in
upholstery brush mode as shown. Use
in upholstery brush mode for cleaning
fabric surfaces such as fabric sofa. See
ATTACHMENT USE TABLE (page 15).
Upholstery
Brush
To return the combination tool to crevice
tool mode, press the release button and
slide the brush tool down the combination
tool.
- 13 -
CAUTION
DO NOT attach or remove handle or
wands while vacuum cleaner is ON.
This could cause sparking and damage
the electrical contacts or electronic
controls.
ATTACHMENTS

Kenmore 400 series Specifications

General

Bagged/Bagless	Bagged
HEPA Filter	Yes
Power Source	Corded Electric
Voltage	120V
Amps	12A
Included Tools	Crevasse tool, upholstery tool
Warranty	1 year limited