- 9 -
FLOOR NOZZLE
Align wand and insert onto floor nozzle
until the wand locks into place.
HANDLE ASSEMBLY
Insert wand into handle until lock button
snaps in place.
Before assembling the vacuum cleaner, check the PACKING LIST (page 2). Use this list to
verify that you have received all the components of your new Kenmore vacuum cleaner.
Please pay special attention to these hazard alert boxes, and follow any
instructions given.
WARNING
statements alert you to such hazards as fire,
electric shock, burns and personal injury.
CAUTION
statements alert you to
such hazards as personal injury and/or property damage.
ASSEMBLY INSTRUCTIONS
WARNING
Electrical Shock Hazard
DO NOT plug into electrical supply until
assembly is complete. Failure to do so
could result in electrical shock or injury.
To remove
: Press wand release button and
pull up on handle.
To store
: Disconnect hose from wand and
canister to prevent stress on hose during
storage.
Store hose in a loosely coiled position so
the hose covering is not stressed.
WAND (TELESCOPING)
The wand length is adjustable and requires
no assembly. To adjust, simply push on the
wand adjust button and slide the upper
wand to the desired height.
NOTE
: When adjusting the wand length
you may have to hold the floor nozzle with
your hand or foot.
To Next Page
Loading...
Need help?
General
