EasyManua.ls Logo

Kenmore 405.84126 - Electrical Requirements and Hazards

Kenmore 405.84126
29 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4
15. The Air Conditioner should be connected to a 115 V, 60 Hz, 15- or 20-amp
fused 3 prong grounded outlet.
16. Always insert the lters securely. Clean them every two weeks. Operation without
lters may cause failures.
OPERATING CONDITION
The Air Conditioner must be operated within the temperature range
indicated below:
Suggested tools for window kit installation:
1. Screwdriver (medium size Phillips)
2. Tape measure or ruler
3. Knife or scissors
4. Saw (In the event the window kit needs to be cut down in size because
the window is too narrow for direct installation)
For Your Safety:
Do not store or use gasoline or other ammable vapors and liquids in the vicinity of
this or any other appliance.
Avoid re hazard or electric shock. Do not use an extension cord or an adaptor plug.
Do not remove any prong from the power cord.
Electrical Information:
Be sure the electrical service is adequate for the model you have chosen. This
information can be found on the serial plate, which is located on the side of the
cabinet and behind the grille.
Be sure the Air Conditioner is properly grounded. To minimize shock and re hazards,
proper grounding is important. The power cord is equipped with a three-prong
grounding plug for protection against shock hazards.
Your Air Conditioner must be used in a properly grounded wall receptacle. If the
wall receptacle you intend to use is not adequately grounded or protected by a tim
e
delay fuse or circuit breaker, have a qualied electrician install the proper receptacle.
Ensure the receptacle is accessible after the unit installation.
MODE ROOM TEMPERATURE
COOL 62ºF F
DRY 55ºF (13ºC) ~ 9F (3C)
WARNING:
WARNING:
(17ºC) ~ 9 (3C)

Related product manuals