Why is my Kenmore Air Conditioner not cool enough?
Your Kenmore Air Conditioner might not be cooling effectively due to several reasons: open windows or doors (close them), nearby heat sources (remove them if possible), a disconnected or blocked exhaust hose (connect it properly and ensure it's functioning), or a temperature setting that is too high (decrease the set temperature).
What to do if Kenmore 408.72012 Air Conditioner does not come on?
If your Kenmore Air Conditioner isn't turning on, check the house circuit breaker panel for a tripped switch. Also, ensure the unit is properly plugged into the outlet. If the internal safety device has tripped, wait 30 minutes; if the problem persists, call 1-800-469-4663 to arrange for product inspection and repair. Finally, check if the safety device on the plug has tripped and reset the safety plug if needed.
Why Kenmore 408.72012 unit does not start when pressing power button?
If your Kenmore air conditioner doesn't start when you press the power button, it could be because the room temperature is higher than the set temperature in heating mode, or lower than the set temperature in cooling mode. Try lowering or raising the set temperature accordingly.
Why does Kenmore 408.72012 Air Conditioner work for only a short time?
If your Kenmore Air Conditioner operates only briefly, check the air exhaust hose for bends or kinks and position it correctly, keeping it as short and free of curves as possible. Also, inspect for and remove any obstacles obstructing air discharge.
Why Kenmore Air Conditioner does not operate for about three minutes after restarting it?
If your Kenmore Air Conditioner doesn't operate immediately after restarting, it could be due to a blocked air filter (clean it). Alternatively, the compressor control might be preventing restart for three minutes after being turned off, which is normal operation, so wait.
Can I turn on Kenmore Air Conditioner immediately after unpacking it?
No. The Kenmore Air Conditioner must be placed upright for at least 12 hours after every transport. Otherwise, the compressor may be damaged.
What does gurgling sound mean in Kenmore 408.72012?
The gurgling sound in your Kenmore Air Conditioner is normal. It comes from the flowing of refrigerant inside the unit.
Guides on selecting an appropriate location for the portable air conditioner unit.
Steps for operating the air conditioner within the room being cooled.
Instructions for using the unit to cool a room from an adjacent location.
Procedures for operating the unit in heating mode within the room.
Instructions for cleaning the air filter to maintain optimal performance.
How to clean the outer casing of the air conditioner unit.
Steps for draining the unit for storage or during periods of non-use.
Explains the meaning of error codes displayed by the unit and their solutions.
General| Type | Portable Air Conditioner |
|---|---|
| Room Coverage | Up to 550 sq. ft. |
| Noise Level | 52 dB |
| Power Supply | 115V/60Hz |
| Weight | 68.3 lbs |
| Refrigerant | R410A |
| Exhaust Hose Length | 5 feet |
| Window Kit Included | Yes |
| Remote Control | Yes |
| Timer | Yes |
| Warranty | 1 year limited |
| Cooling BTU | 12000 BTU |
To Next Page
