INSTALLATION INSTRUCTIONS
CONNECT TO THE POWER SUPPLY
Plug the power cord into a 3-prong, well grounded 120 volt 60
Hz approved electrical outlet protected by a 15-amp fuse or
comparable circuit breaker.
Your washer is grounded through the third prong of the power
cord when plugged into a three-prong grounded receptacle.
LEVELING THE WASHER
1. Slide your washer into position.
2. Level your washer by turning the
leveling legs in or out as necessary
by hand or by using the wrench
included with your washer.
When your washer is level, tighten
the locking nuts using the wrench
or (-) flathead screwdriver.
NOTE: Your washer must be leveled
on all four sides. A carpenter’s level
should be used on all four corners of
your washer. It’s the best to recheck
after the first dozen washes.
NOTE: Avoid damage to the legs. Do not move the washer unless
the lockingnuts are fastened to the bottom of the washer.
• All four leveling feet must rest solidly on the floor. Attempt to
rock the washer from corner to corner to make sure that all four
leveling feet are in firm contact with the floor.
The drum of your new washer spins at very high speeds.
To minimize vibration, noise, and unwanted movement, the floor
must be a level, solid surface.
NOTE: Adjust the leveling feet only as far as necessary to level
the washer. Extending the leveling feet more than necessary can
cause the washer to vibrate.
Level
Leveling Feet
Leveling Feet
592-49032-02855B-01_EN_v1.indd 10 2011-07-22 �� 11:42:12
To Next Page