BEFORE CALLING FOR SERVICE (continued)
Water in the washer drains
slowly or nat at all, or the
display shaws: I
The display shaws: I
UC
I-
UC I
The dlsplay shows: I I ll-UC I
The display shaws: I rrrl=|
The display shows: I I_l-i-c|
I I-
The display shaws: I I_C I
The display shaws: _ i-i-
r_o-_,|
Drain hose is kinked, pinched, or clogged.
Drain discharge is more than 96 inches
above bottom of washer.
The washer has detected an out of balance
load.
If the uE rebatance (see above) is not
successful, this error will be displayed.
The load is too small.
Heavy articles are mixed with lighter items.
The load is out of balance.
Control error.
Water level is too high due to a faulty
water valve.
The water level sensor is not working
correctly.
A motor error has occurred.
Clutch error.
Make sure the drain hose is free of clogs,
kinks, etc., and is not pinched behind or under
the washer.
Adjust or repair drain. Maximum drain
height is 96 inches (8 ft.)
If the washer detects a load that is too far
out of balance to spin_ it will display this code
while it is attempting to rebalance the load.
The washer will add water and try to redis-
tribute the load automatically. This display
is for your information only_ and no action is
required.
The automatic affempt to rebalance the load
was not successful.The cycle has been paused to
allow the load to be manually adjusted.
Small loads may need additional itemsto be
added to allow the washer to balance the loads.
The toad may have heavy itemsloaded with
lighter items. Always try to wash articles of some-
what similar weight to allow the washer to evenly
distribute the weight of the load for spinning.
Manually redistribute the load if articles have
become tangled preventing the automatic
distribution from working properly.
Unplug the washer and wait 60 seconds.
Reconnect power and try again, if the error
reappears, call for service.
Close the water faucets, unplug the washer,
and call for service.
Close the water faucets, unplug the washer,
and call for service.
Allow the washer to stand for 30 minutes
and then restart the cycle. If the LE error
code persists, call for service.
Mechanical failure.
Unplug the washer and call for service.
33
To Next Page
Loading...
