UNPACKING AND REMOVING SHiPPiNG MATERIAL
When removing the washer from the carton base, be sure
the plastic tub support comes off: with the base.
if you must lay the washer down to remove the base
packaging materials, always protect the side of the
washer and lay it carefully on its side. DO NOT lay the
washer on its front or back.
t t
Tub support Carton Base
lo
After removing the carton and shipping material,
lift the washer off: the foam base. Make sure the
plastic tub support comes off: with the base and is
not stuck to the bottom of the washer.
f
J
2. Save the foam block for future use. If the washer
must be moved in the future, this will help prevent
damage to the washer during transportation.
NOTE: To prevent damage, do not remove the foam
block until the washer is at the final location.
f
\ J
3. Unfasten the power cord from the back of the washer.
fTOOLS YOU WILL NEED
• Adjustable Pliers
• Carpenter's Level
J
To Next Page
Loading...
