27
Oven Controls
To increase (+) or decrease (-) the oven temperature by 20°F:
1. Press and hold Bake until the control provides an audible
tone (about 6 seconds). The factory offset temperature of 0
(zero) should appear in the display.
2. Enter 2 0 using numeric keypad.
3. Press Flex Clean to toggle between plus (+) if increasing
temperature or minus (-) if decreasing the temperature.
4. Press to accept change.
Important note:
• Oven temperature adjustments made will not change the
Broil or Flex Clean function temperatures.
• If the temperature shows an adjustment of -20°F, and a
+20°F adjustment is needed, you can toggle between the
minus (-) or plus (+) in the display when pressing Flex Clean
key (See Step 3).
• Do not use oven thermometers such as those found in
grocery stores to check the temperature settings inside your
oven. These oven thermometers may vary as much as 20 to
40°F degrees from actual temperatures.
• The oven temperature adjustment may be made if your
oven control has been set to display °C temperatures.
Minimum and maximum settings for °C range from plus
(+)19°C to minus (-) 19°C.
Restoring factory default settings
When new, your appliance left the factory with predetermined
(default) oven control settings. Over time, users may have made
changes to these settings. The following options may have been
modified since the appliance was new:
• 12 or 24 hour display mode
• Continuous bake or 12-Hour Energy Savings mode
• Silent or audible control
• Oven temperature display (°F or °C)
• Oven temperature adjustments
• Stored recipes
If you choose to restore factory default setting
using this method, all of the above user settings will be restored
to the factory default settings. This includes the oven tempera-
ture offset that will reset to (0) zero and any stored recipe infor-
mation will be cleared.
To restore oven control to factory default settings:
1. Press and hold 7 until acceptance tone sounds (about 6
seconds).
2. Press . The control has been reset with the default
settings.
Operating oven lights
The interior oven lights will automatically turn ON when the
oven door is opened.
Press to turn the interior oven lights ON and OFF whenever
the oven door is closed. The oven light will not operate during a
self-clean cycle.
The interior oven lights are located on the rear wall of the oven
interior and are covered with a glass shield. The glass shield
protects the bulb from high temperatures and should always be
in place whenever the oven is in use.
To replace the interior oven light, see “Replacing the oven
interior light” on page 36.
To Next Page
Loading...
Need help?
General