NOTE
: DO NOT bend or crease the
middle of the cardboard when installing
the bag into the bag mount slots.
6. Rotate bag mount down and install
bag into slots per illustration, pushing
down until the cardboard tab locks into
position and the holes align.
7. Tuck the bag securely into the bag
cavity so that none of the bag will be
pinched by the hood.
8. Close and latch canister hood.
9. Insert hose into canister until it snaps in
place.
10. Plug cord into wall outlet.
MOTOR SAFETY FILTER
Check motor safety filter occasionally and
clean when dirty.
NOTE
: See REPLACEMENT PARTS for
part number and purchase details (page 6).
1. Remove the bag as outlined in the DUST
BAG CHANGING (page 18-19) section.
2. Lift the rubber retainer and pull out
motor safety filter as shown.
- 19 -
CAUTION
NEVER REUSE A DUST BAG.
Very fine materials, such as carpet
freshener, face powder, fine dust,
plaster, soot, new carpet lint, etc. can
clog the bag and cause it to burst before
it is full, which may damage the vacuum
cleaner motor. Change bag more often
when vacuuming these materials.
WARNING
Electrical Shock Hazard
Turn off and unplug vacuum cleaner
from electrical outlet. Do not operate
the vacuum cleaner without the motor
safety filter. Be sure the filter is dry
and properly installed to prevent motor
failure and/or electrical shock.
DUST BAG CHANGING
MOTOR SAFETY FILTER CLEANING
To Next Page
Loading...
Need help?
General
