gNSTALLATJON
Remove all packing matedal and accessories. Examine the even for any damage
such as dents or broken door. Do not install if oven is damaged.
NOTE: This unit is not designed for 50 Hz or any circuit other than a !20-volti60-Hz
AC circuit. This oven is designed for ceuntertop installation.
Ceuntertop Installation 1
1. Select a level surface that provides
enough open space for the intake
and/or outlet vents.
OPEN
,_ Leave a minimum clearance of
3 inches around the oven. One side
must be open.
Leave a minimum clearance of
3 inches above the oven.
o Do not remove the legs from the
bottom of the oven.
o Blocking the intake and/or outlet
openings can damage the oven.
2. Plug your oven into a standard 120-
volt / 60-Hz household outlet. Be
sure the electrical circuit is at least
15 amperes and that your
microwave oven is the only
appliance on the circuit.
WARNING: Do not install oven over a
range cooktop or other heat-producing
appliance, If installed near or over a heat
source, the oven could be damaged and
the warranty would be void.
To Next Page
Loading...
Need help?
General
