Kenmore Front Load Washer - Connecting Drain and Electrical

10
NOTE
A wiring diagram and technical data sheet are located under
the washer top panel, on top of the detergent dispenser
housing.
NOTE
After you plug in the washer the fi rst time, the washer will
power up on its own. It will take approximately one minute
for the LCD to perform initial boot up procedures.
Grounding type
Grounding type
wa
wa
ll receptacl
ll receptacle
Po
Po
wer cord with
wer cord with
3-prong
3-prong
gr
gr
ounded plug
ounded plug
Do not,
Do not,
under
under
an
an
y cir
y cir
cumstances,
cumstances,
cut,
cut,
remo
remo
ve
ve,
or b
or b
ypass th
ypass the
gr
gr
ounding pr
ounding pr
ong.
ong.
CABLE TIE
Connecting drain and electrical
1 Snap one end of the drain hose hanger (shipped in
washer drum) onto the drain hose. Continue wrapping it
around the hanger and snap it in place.
2 Place the hook end of the drain hose in the drain
opening. Secure the drain hose with the cable tie
(provided in the enclosure package) to the standpipe,
inlet hose, laundry tub, etc. so the hose does not pull out
from the force of the water.
3 Plug the power cord into a grounded outlet.
4 Turn on the power at a circuit breaker/fuse box.
5 Carefully slide the washer to its fi nal position. Recheck
for level and rock corners for stability. Remove and
discard door tape.
6 Read the
Use & Care Guide provided with the washer. It
contains valuable and helpful information that will save
you time and money.
7 See the next page about performing a brief, helpful
“Installation Cycle” for your new washer.
8 If you have any questions during initial operation, please
review the “Avoid Service Checklist” in your
Use & Care
Guide
before calling for service.
9 Place these instructions in a location near the washer for
future reference.
IMPORTANT
Check to ensure the power is off at a circuit breaker/fuse
box before plugging the power cord into an outlet.
Installation Instructions