12
1
2
3
4
Reversing Door Swing
Removing the door
Open washer door and remove the 4 hinge screws.1.
12
IMPORTANT
DO NOT remove the hinge or strike support block.
HINGE
STRIKE
SUPPORT
BLOCK
WARNING
ELECTRICAL SHOCK HAZARD
Failure to disconnect power source
before servicing could result in personal
injury or even death.
Be sure you have adequate swing area before 1.
reversing door.
You will need a screw driver with a #2 square and 2.
straight bit.
Protect fl at work surface, such as top of washer or 3.
fl oor near washer, with a soft cloth or towel.
Be sure washer is unplugged from power source!4.
Screwdrivers with
#2 square &
straight bit
Tools needed:
Supporting door with both hands, squarely slide door 2.
and hinge outward approximately 3/8” (10 mm) so
hinge can be pulled from
shoulder bolts on front
panel.
Gently place washer door face down on fl at, covered 3.
work surface.
Remove 2 pan head screws and door strike from inner 4.
door.
Locate the 15 indented head screws - 8 in the small, 5.
circular recesses at top and bottom edge of the inner
door, 2 on the latch-side edge, and 5 on the hinge-side
edge. Remove and save these 15 screws.
Separate inner door assembly from outer door 6.
assembly.
1
8
2
9
3
10
11
12
13
15
14
4
5
6
7
Do not attempt
to remove the 2
shoulder bolts.
To Next Page
Loading...
