Kenmore Garbage Disposal - Check the Parts and Mounting Assembly; Mounting Assembly Components

INSTALLATION DIMENSIONS
A
I
DRAWING REPRESENTATIVE OF
A FOOD WASTE DISPOSER
IMPORTANT:PLUMB WASTELINE TO PREVENTSTAND-
ING WATERINDISPOSERMOTORHOUSING.
NOTE: Please refer to the
dimensions which match
your disposer model number.
B" - DISTANCE FROM
BOTTOM OF SINK TO
CENTER LINE OF
DISPOSER OUTLET,
ADD 1/2"WHEN STAINLESS
STEEL SINKS ARE USED,
E" - LENG'R,_ OF
DISCHARGE TUBE FROM "
CENTER UNE OF
DISPOSER OUTLET TO
END OF DISCHARGE
TUBE.
OKAY, LET'S START THE
INSTALLATION ONE
STEP AT A TIME.
b
CHECK THE PARTS AGAINST THE DRAWINGS BELOW
AND MAKE SURE EVER,..YTHING IS THERE. (your new
disposer may not look hke the one pictured.)
_ _) SE( F-SERVICE
"WRENCHETTE"
(1/4INCH HEX WRENCH)
DISCHARGE TUBE, GASKET,
METAL FLANGE AND SCREW(S)
THE MOUNTING ASSEMBLY
CONSISTING OF:
Sink sleeve
Fiber gasket
Back-up ring
Mounting ring
and 3 screws
Snap ring
_/o_17 °
(__/' _oie_ing
/