34
CARE AND CLEANING
1. Water Dispenser
• Clean the water collecting tray with a sponge or
absorbent cloth.
2. Ice Storage Bin
• Removing: Pull out and remove the ice cube bin.
Make sure the refrigerator door is open completely
before pulling out the ice cube bin.
• Replacing: Push the ice cube bin all the way back
onto the supports until it locks into position. If the
bin cannot be pushed all the way back, rotate the
ice auger a quarter turn and insert again. Make
sure the refrigerator door is open completely before
replacing the ice cube bin.
3. Freezer & Refrigerator Bins
• Hold both ends and pull up.
4. Refrigerator Shelves
To remove a shelf: Lift up
on front of shelf with one
hand and with other hand
push up on back of shelf
to release attachment
hooks from attachment
slots. Pull the shelf out.
To reinstall a shelf: With
front of shelf angled
slightly up, engage hooks
on back of shelf into
attachment slots, and
then lower front of shelf
into place.
CAUTION
: Make sure that shelves are level from one
side to the other. Failure to do so may result in the shelf
falling or spilling food.
3
3
Slim IceMaker
CLOSEOPEN
Kenmore향 31 큐빅(영+스)_F840-2(KLBH031A@E).indd 34 2021-03-23 오후 3:22:39
To Next Page
Loading...
Need help?
General
