- 10 -
CHARGING
Battery Charging Indicator
NOTE:
The vacuum cleaner sits in the
charger base and is held into position while
charging by the support rails. Ensure you
place the vacuum cleaner downwards onto
the charger base and ensure the vacuum is
correctly docked. Make sure that there is
nothing obstructing the connections which
may prevent charging.
6. While the vacuum cleaner is being
charged, the battery charging indicator
will flash continuously until fully charged.
7. When the vacuum has reached full
charge (100%), the battery charging
indicator will turn off.
NOTE:
If the battery charging indicator
does not illuminate when charging, ensure
that:
• The vacuum cleaner is seated properly
onto the charger base.
• The charging plug is plugged into the
power supply properly.
• The electrical supply at the outlet is
powered on.
• The charging connector is fully inserted in
the charger base.
NOTE:
For improved battery
performance, always keep the vacuum
cleaner on the charging base while not in
use.
OPERATING INSTRUCTIONS
USING YOUR VACUUM CLEANER
Before vacuuming, check that the brush roll
is clear from any obstructions such as hair
or sharp objects to avoid scratching floors,
and that the dust cup is empty.
NOTE:
Use the low-speed setting for
cleaning of hard floors, and low pile rugs.
The high-speed setting should be used for
cleaning plush rugs and carpets or when
additional cleaning power is required.
CAUTION
Moving parts! To reduce the risk of personal injury, DO NOT
touch the brush roll when vacuum is on. Contacting the brush
roll while it is rotating can cut, bruise or cause other injuries.
Always turn off before servicing. Use caution when operating
near children or pets.
To Next Page
Loading...
Need help?
General
