Ca ing
iVlachine !i
Fig 1
Fig 1 Cleaning the feed dogs with a
brush,,
To insure the best possible operation
of your machine, it is necessary to
keep the essential parts clean at all
times, Using a small brush, remove the
lint that accumulates in the shuttle
area and around the feed dogs,
Fig,. 2 Parts of the Shuttle Assembly
Lever-_
4_Lever
Shuttle Assembly
ShuttIe Race Cover
Pointed --_
hook Shuttle
Shuttle driver
!
Shuttle Race
To
,
Clean the Shuttle Area:
This area must be kept free of dust,
lint and occasional tangled thread,
Raise the needle bar to its highest
point and remove the bobbin case_
Push levers of shuttle race aside and
lift shuttle race cover and shuttle
out,
3, Clean the shuttle race with small
brush,
4., Put a drop of oil on the center pin
of the shuttle and shuttle race, (see
arrows)
To Replace Shuttle Assembly:
1, Position shuttle race as illustrated
so that race is forming half moon
on the left side of the machine
2, Hold shuttle by center- pin and posi-
tion shuttle so as to form a half
moon on the right side Pointed
hook will be on the bottom,
3. Place shuttle race cover into place
over shuttle assembly.
4, Snap the levers into position
Fig. 2
To Next Page
Loading...
