_i'.:iii,;] ii::.![,i ":-i-ii:;iE{] [,: {:,:!,i{_i iG
®
®
o
®
®
®
3
t
1, Release clutch by turning clutch
knob toward you,
2, Draw thread from spool through
bobbin winder tension disc as
shown,,
3, Pull end of thread th[ough hole in
bobbin as shown,.
4. Place bobbin onto bobbin winder
shaft with end of thread coming
from the top of the bobbin,, Push
bobbin ,winder shaft to the right
until it clicks, Holding onto end of
thread, start machine, When bobbin
is slightly filled, snip off end of
thread.
5, Start machine. Wind thread until
bobbin winder' shaft releases,
6. Tighten clutch knob and remove
bobbin,
To Next Page
Loading...
