Kenner KNL100E-01 User Manual

Please note that the wire connection of the power supply syste
connection will damage the control board.
WARNING: NEVER connect the gate opener to the power outlet before all the installations have been
done.
1. Use the batteries
as the power source
the batteries
The “ 24V+”
of the battery should be wired to the
terminal. The wire (2*0.75mm
2
,
1meter
connected to the control board in factory.
terminals of the control board, no matter the polarity.
distance between the outlet and the control box is longer than that, you should use an extended wire to connect
the adapter to the control board. The wire size should be at least 16
(300’), the wire si
ze should be at least 14
300m (1000’).
You can plug the adapter
into the electrical o
connections are completed
. Use a surge protector
strongly recommended.
If electrical outlet is
adapter should be protected by a
weatherproof cover.
2. Use the batteries
as the power source
adapter & solar panel to charge the batteries at the
same time
If you want to use an optional
solar panel
charge controller must be used to control it to charge the battery. You can connect adapter, the solar panel and
the solar charge controller refers
to the following il
12
Please note that the wire connection of the power supply syste
m is very important. Incorrect wire
connection will damage the control board.
WARNING: NEVER connect the gate opener to the power outlet before all the installations have been
as the power source
and only use the adapter to char
of the battery should be wired to the
BAT+ (#11) terminal, “ 24V-”
should be wired to
1meter
long) for connecting the battery has been provided and
connected to the control board in factory.
The adapter
should be wired to the
terminals of the control board, no matter the polarity.
The length of the wire of the adapter is
distance between the outlet and the control box is longer than that, you should use an extended wire to connect
the adapter to the control board. The wire size should be at least 16
AWG
. If the distance is more than
ze should be at least 14
AWG
. The maximum distance from the adapter to the control box is
into the electrical o
utlet after all the wire
. Use a surge protector
with the adapter is
If electrical outlet is
located outdoors, outlet and
weatherproof cover.
as the power source
and use the
adapter & solar panel to charge the batteries at the
solar panel
to charge the battery
with the adapter at the same time
charge controller must be used to control it to charge the battery. You can connect adapter, the solar panel and
to the following il
lustration.
m is very important. Incorrect wire
WARNING: NEVER connect the gate opener to the power outlet before all the installations have been
and only use the adapter to char
ge
should be wired to
“ BAT-” (#12)
long) for connecting the battery has been provided and
“ ADAPTER” (#13, #14)
The length of the wire of the adapter is
1.2m (4’). So if the
distance between the outlet and the control box is longer than that, you should use an extended wire to connect
. If the distance is more than
100m
. The maximum distance from the adapter to the control box is
with the adapter at the same time
, a solar
charge controller must be used to control it to charge the battery. You can connect adapter, the solar panel and

Kenner KNL100E-01 Specifications

General

Brand	Kenner
Model	KNL100E-01
Category	Gate Opener
Language	English