1. Loosen the seat clamp nuts.
2. Insert the top portion of the seat post into the seat clamp. Be sure the seat
post is completely inserted into the seat clamp and butted tightly against the
underside of the seat.
3. Tighten seat clamp nuts securely.
4. Insert the seat post (with seat attched) into the bike frame. Be sure that the
seat post is inserted past the minimum insertion line.
5. Tighten the seat post binder bolt securely at the desired height.
6. Adjust the angle of the seat so that the top of the seat is parallel to the
ground or comfortable to the rider.
7. Retighten the seat clamp nuts securely. Check for tightness by attempting to
twist the seat. If the seat is loose, be sure to tighten the clamp nuts and binder
bolt securely. Torque requirement 15-20 ft. lbs.
THE SEATPOST “MINIMUM INSERTION” / “MAXIMUM HEIGHT” MARK
SHOULD NOT BE VISIBLE WHEN THE SEAT POST IS INSERTED INTO THE
SEAT MAST OF THE BIKE. DO NOT RAISE THE SEAT POST BEYOND THIS MARK.
THE SEAT POST MAY BREAK CAUSING YOU TO LOSE CONTROL AND FALL.
ALWAYS CHECK TO MAKE SURE SEAT POST ADJUSTING MECHANISM IS TIGHT-
ENED SECURELY BEFORE RIDING. RIDING WITH AN IMPROPERLY TIGHTENED
SEAT POST CAN ALLOW THE SEAT TO TURN OR MOVE AND CAUSE THE RIDER
TO LOSE CONTROL
To Next Page
Loading...
