Need help?Do you have a question about the Kentix MultiSensor-LAN and is the answer not in the manual?
General| Housing Material | Plastic |
|---|---|
| Protection Class | IP20 |
| Power Supply | PoE (Power over Ethernet) or 12-24V DC |
| Humidity Range | 0 to 100% RH (non-condensing) |
| Connectivity | Ethernet 10/100Base-T |
| Sensors | Temperature, Humidity, Motion, Light |
| Protocols | SNMP, HTTP, HTTPS, SMTP |
| Alarming | Email, SNMP, Syslog |
| Certifications | CE |
| Product Type | Environmental Sensor |
Emphasizes the need for competent installation and safe operation, including power failure considerations.
Details expert installation requirements and adherence to relevant regulations for correct operation.
Details default network configuration, user credentials, and IP address for initial setup.
Provides instructions for resetting the device's login information and IP address to default settings.
Configuration of the device's IP address, subnet mask, and gateway for network connectivity.
Enabling and configuring communication with the Kentix AlarmManager.
Setting up SMTP/ESMTP servers and recipient addresses for alarm notifications.
Configuring Simple Network Management Protocol for network monitoring and traps.
Setting alarm thresholds for temperature, humidity, and dew-point with hysteresis.
Configuring sensitivity and trigger points for carbon monoxide detection.
Provides contact details, including company address and support email for technical inquiries.
To Next Page