Kentix MultiSensor-LAN - Control a Network Camera Via HTTP Requests

Control a network camera via HTTP requests
Th MultiSensor-LAN offers the possibility to send in case of an alarm a control frequency as a HTTP request
to any IP ready network camera. So you can additional to the e-mail alerting also received a video picture or
a video sequence. The transmission from the video picture is done by the camera.
You can find the information to control the camera in the „cam.ini“ file. Create this file with a text editor and
copy this via FTP to the root directory from the MultiSensor, there where is also the „config.ini“ file. After a
reboot the configured command sequence will send to the camera in case of an alarm. Up to five cameras
can be controlled, create for each camera a new line in the „cam.ini“ file.
File content (cam.ini)
IP-ADDRESS;IP-PORT;HTTP-CAM-COMMAND;HOST-ADDRESS;SERVER-NAME
The delimiter for each parameter is a semicolon.
EXAMPLE: File content (cam.ini)
192.168.100.224;80;/cam/command/input=trigger;www.kentix.de;My-Camera
The HOST address can be any, is required by some camera servers.
EXAMPLE: File content (cam.ini) for AXIS Video Server 240
192.168.100.224;80;/axis-cgi/io/virtualinput.cgi?action=6:/;www.kentix.de;Axis-Server240
Page 11 ! (09-2012, subject to change)! www.kentix.de