Why Kenwood Fryer does not work?
If your Kenwood Fryer isn't working, there are a couple of things to check: First, make sure the fryer is properly plugged into the power outlet. Second, inspect the fuse or circuit breaker for your installation and replace the fuse if necessary. If the problem persists after checking these, refer to the service section.
What to do if Kenwood Fryer oil overflowing?
If the oil is overflowing in your Kenwood Fryer, consider these potential causes and solutions: 1. **Maximum oil level exceeded**: Check the oil level and adjust accordingly. 2. **Basket overloaded/maximum chip capacity exceeded**: Refer to the frying chart for recommended quantities to avoid overloading the basket. 3. **Wet food placed in oil**: Ensure food is thoroughly drained and dried before frying. 4. **The oil is old and has deteriorated**: Replace the old oil with fresh oil. 5. **Incorrect oil used/different oils mixed together**: Use a good quality oil suitable for deep frying.
Why does my Kenwood DEEP have an unpleasant odour or the oil smokes?
An unpleasant odour or smoking oil in your Kenwood Fryer can be due to a couple of reasons: The oil might be old and deteriorated, in which case you should replace it with fresh oil. Alternatively, the oil may not be suitable for deep frying; ensure you are using a good quality oil specifically designed for deep frying.
How to improve poor frying performance in Kenwood Fryer?
If you're experiencing poor frying performance with your Kenwood Fryer, here are a few things to consider: * **Incorrect temperature used**: Make sure you've selected the correct temperature for the food you're frying. * **Basket overloaded**: Reduce the quantity of food you're frying in each batch. * **Fresh chips too wet**: Ensure that fresh chips are thoroughly drained and dried before adding them to the fryer.
General| Adjustable thermostat | Yes |
|---|---|
| Cool zone | Yes |
| Removable bowl | Yes |
| Material | Stainless Steel |
| Safety Features | Overheat protection |
Ensure electricity supply matches the fryer's underside specification.
Remove packaging, dismantle, and wash parts before initial use.
Open lid by pushing release, then lift lid. Remove basket by lifting handle.
Pour oil to MAX/MIN level, insert basket, lower handle, close lid, plug in, select temperature.
Wipe outer body with damp cloth, dry thoroughly. Do not immerse in water. Clean inner bowl with hot soapy water.
Remove and soak lid in hot soapy water for 20 minutes after each use.
Remove and soak basket in hot soapy water for 20 minutes, then use a stiff brush. Dishwasher safe.
Refer to troubleshooting guide for operation problems before calling for assistance.
To Next Page
