Kenwood DF560 series User Manual (English)

Other manuals for Kenwood DF560 series

Questions and Answers:

G
Gordon RomeroJul 30, 2025
Why is my Kenwood Fryer oil overflowing?
- D
  Donna PollardJul 30, 2025
  Oil overflowing in your Kenwood Fryer can occur for several reasons: the oil level may be too high, the basket might be overloaded, wet food was placed in the oil, the oil is old, or an incorrect type of oil is being used. Check the oil level, refer to the frying chart for recommended quantities, ensure food is drained and dried, replace old oil with fresh oil, and use a good quality oil suitable for deep frying.
M
Mrs. Carla FrenchAug 5, 2025
What to do if my Kenwood DF560 doesn't work?
- B
  Barbara BerryAug 5, 2025
  If your Kenwood Fryer isn't working, make sure it's properly plugged in and that the ON/OFF button is in the ON position. Also, check the fuse or circuit breaker and replace the fuse if needed. Finally, ensure the electronic control unit is correctly inserted.
M
Michael FlynnAug 10, 2025
Why does my Kenwood Fryer have a unpleasant odour or oil smokes?
- H
  Hayley WrightAug 10, 2025
  An unpleasant odor or smoking oil in your Kenwood Fryer typically means the oil is old and has deteriorated, or the oil is not suitable for deep frying. Replace the old oil with fresh, good quality oil that is suitable for deep frying.
D
Dominique FloresAug 14, 2025
Why is my Kenwood Fryer's frying performance poor?
- B
  Betty Harvey MDAug 14, 2025
  Poor frying performance with your Kenwood Fryer can be due to several factors. You might be using the wrong temperature, overloading the basket, or the fresh chips are too wet. Also, consider using the batch method for fresh chips: fry at 170°C for 9–11 minutes, then increase the temperature to 190°C and cook for another 1–2 minutes. Ensure you select the correct temperature, reduce the quantity fried, and thoroughly drain and dry the chips.
A
Anna MitchellAug 19, 2025
Why is the red light on my Kenwood DF560 temperature control unit on?
- M
  Mark BrownAug 19, 2025
  The red light on the temperature control unit of your Kenwood Fryer indicates that the oil change light is operating. Clean the fryer, change the oil, switch the fryer on, and reset the button by pressing and holding it in for 2-3 seconds.
T
Teresa HoweAug 25, 2025
Why is the temperature light solid and not flashing on my Kenwood Fryer?
- A
  Anthony GarciaAug 26, 2025
  If the temperature light on your Kenwood Fryer is solid and not flashing, this is normal operation. It means the correct frying temperature hasn't been reached yet or the temperature hasn't recovered from the previous frying session. Wait for the light to start flashing before frying.