Why is Kenwood DNX5380BT GPS radio reception poor?
If your Kenwood GPS radio reception is poor, first, ensure the car antenna is fully extended. If the issue persists, check that the antenna control wire is correctly connected, referring to the 'Connection' section in the Quick Start Guide.
What to do if I cannot select the output destination of the subsource in the dual zone on my Kenwood DNX5380BT GPS?
If you cannot select the output destination of the subsource in the dual zone of your Kenwood GPS, it might be because the dual zone function is disabled. To solve this, turn the dual zone function on. See Zone Control (P.86).
Why I cannot adjust the volume of the rear speakers on my Kenwood GPS?
If you cannot adjust the volume of the rear speakers on your Kenwood GPS, it's likely because the dual zone function is disabled. Enable the dual zone function to resolve this. See Zone Control (P.86).
What to do if there is no output from the subwoofer on Kenwood DNX5380BT GPS?
If there's no output from the subwoofer on your Kenwood GPS, the subwoofer might not be enabled. Turn on the subwoofer. See Speaker setup (P.80).
General| Display Resolution | 800 x 480 pixels |
|---|---|
| Touchscreen | Yes |
| Navigation | Yes |
| Bluetooth | Yes |
| USB Port | Yes |
| SD Card Slot | Yes |
| DVD Player | Yes |
| Rear View Camera Input | Yes |
| Audio Formats Supported | MP3, WMA, AAC |
| Built-in Amplifier | Yes |
| AUX Input | Yes |
| CD Playback | Yes |
| AM/FM Tuner | Yes |
| Voice Control | Yes |
| Steering Wheel Control | Yes |
| iPod/iPhone Control | Yes |
| Display Type | LCD |
| Video Formats Supported | MPEG-1, MPEG-2, DivX |
| Preamp Outputs | 3 pairs |
| Display Size | 6.1 inch |
To Next Page
