Why is the Kenwood DNX691HD GPS radio reception poor?
Poor radio reception in your Kenwood GPS could be due to a couple of reasons. First, make sure the car antenna is fully extended. Also, check that the antenna control wire is properly connected.
Why can't I set up the equalizer on my Kenwood DNX691HD?
If you're having trouble setting up the equalizer on your Kenwood GPS, it might be because the dual zone function is currently enabled. Try turning the dual zone function off.
Why can't I adjust the volume of the rear speakers on my Kenwood GPS?
If you can't adjust the volume of the rear speakers on your Kenwood GPS, the dual zone function may be disabled. To resolve this, set the dual zone function to 'on'.
Why can't I set up the crossover network on my Kenwood DNX691HD GPS?
If you're unable to set up the crossover network on your Kenwood GPS, it could be because the dual zone function is enabled. You should set the dual zone function to 'off'.
Why can't I set up the low pass filter on my Kenwood GPS?
If you're unable to set up the low pass filter on your Kenwood GPS, ensure that the subwoofer is set to 'on'.
Why can't I set up the high pass filter on my Kenwood GPS?
If you're having trouble setting up the high pass filter on your Kenwood GPS, the problem might be that the subwoofer is not turned on. Set the subwoofer to 'on'.
Why can't I select the output destination of the subsource in the dual zone on my Kenwood DNX691HD?
If you're unable to select the output destination of the subsource in the dual zone on your Kenwood GPS, it's possible that the dual zone function is disabled. Set the dual zone function to 'on'.
What to do if I cannot set up the Kenwood GPS subwoofer?
If you are unable to set up the subwoofer on your Kenwood GPS, it might be because the subwoofer is not turned on. Make sure to enable the subwoofer in the settings.
What to do if there is no output from the Kenwood GPS subwoofer?
If there is no output from the subwoofer of your Kenwood GPS, the subwoofer may not be activated. Ensure that the subwoofer is set to 'on'.
Why I cannot set up the low pass filter on my Kenwood GPS?
If you cannot set up the low pass filter on your Kenwood GPS, it is probably because the subwoofer is not turned on. Ensure that the subwoofer is activated.
General| Display Size | 6.95 inches |
|---|---|
| Resolution | 800 x 480 pixels |
| GPS Navigation | Yes |
| Bluetooth | Yes |
| USB Ports | 1 |
| Touchscreen | Yes |
| HD Radio | Yes |
| SiriusXM Ready | Yes |
| App Control | Yes |
| Audio Formats Supported | MP3, WMA, AAC |
| Video Formats Supported | MPEG-1, MPEG-2, MPEG-4, WMV |
| Preamp Outputs | 3 |
To Next Page
