Kenwood DNX693S User Manual

Setting Up
83
Audio SETUP Clear
Clears the AUDIO SETUP Memory and the
currently memorized audio setting.
Software Information
Check the software version of this unit.
(P.83)
Open Source Licenses
Displays the open source licenses.
Initialize
Touch [Initialize] and then touch [Yes] to set all
the settings to the initial default settings.
• Audio SETUP Memory is not initialized.
Software Information
Check the software version of this unit.
1 Touch [Software Information] in the
Special screen.
Software Information screen appears.
2 Confirm the software version.
NOTE
• For how to update the software, see the relevant
update procedure manual which comes with the
software.
Security Setup
You can set up a security code to protect
your receiver system against theft.
1 Press the <MENU> button/
volume knob.
Popup menu appears.
2 Touch [SETUP].
SETUP Menu screen appears.
3 Touch [Security].
Security screen appears.
4 Set each item as follows.
SI
A red indicator will blink on the unit after the ACC
is set to OFF, warning potential thieves. If turned
to “ON” (default), the security indicator on the
front panel flashes when the vehicle ignition is off.
Security Code Set *
1
Register the security code for the unit.
Security Code Cancellation *
1
Clear the security code.
Security Code Change *
1
Change the security code.
*1 DNX7160BTS/ DNX5160BTS only

Kenwood DNX693S Specifications

General

Brand	Kenwood
Model	DNX693S
Category	GPS
Language	English