17-5. Bluetooth detail setting
You can configure the initial settings of this unit.
1. Press the [Ú] button.
"BT MODE" appears and enter the Bluetooth mode.
2. Use the [Control knob] to select "SETTINGS" > "DETAILED SET".
For how to use the [Control knob], refer to <3-3. How to select the item>.
3. Use the [Control knob] to select an Bluetooth detail setting item.
Display Description
"AUTO
ANSWER"
Automatically answers a call after lapse of the preset time interval.
"OFF": Does not answer the phone call automatically.
"1" – "8" – "99":
Automatically answers the phone call after lapse of 1 – 99 seconds.
"RECONNECT"
When set to "ON", starts re-pairing with the registered Bluetooth device
automatically when it becomes unpaired.
"ON" / "OFF"
"AUTO
PAIRING"
When set to "ON", performs Bluetooth pairing automatically when the
iPhone is connected to the USB terminal.
"ON" / "OFF"
"BT
HF/AUDIO"
Specifies the output speakers for hands-free voice communication and
Bluetooth audio sound.
"FRONT" : Outputs sound from the front speakers.
"ALL" : Outputs sound from the front and rear speakers.
"CALL BEEP"
Sets whether to output a beep from the speaker when a call comes in.
"ON" : Outputs a beep.
"OFF" : Does not output a beep.
"MIC GAIN"
Adjusts the sensitivity of the microphone for telephone call or adjusts
the voice of the caller.
"-20" – "0" – "+8"
"ECHO
CANCEL"
Sets the echo cancellation level.
"1" – "4" – "10"
(Colored text: Factory setting)
4. Use the [Control knob] to select a setting.
The previous item appears.
Exit the Bluetooth mode.
Press the [Ú] button.