Need help?Do you have a question about the Kenwood KA-9800 and is the answer not in the manual?
General| Frequency Response | 5Hz to 50kHz |
|---|---|
| Speaker Load Impedance | 4Ω to 16Ω |
| Weight | 12.5 kg |
| Type | Integrated Amplifier |
| Total Harmonic Distortion (THD) | 0.03% |
| Input Sensitivity | 2.5mV (MM), 150mV (line) |
| Signal-to-Noise Ratio | 100 dB |
| Output | 150mV (line) |
| Channel Separation | 60 dB |
| Power Output | 100 watts per channel into 8Ω (stereo) |
| Damping Factor | 50 (8 ohms) |
Detailed description of the preamplifier circuit and its gain.
Description of the power amplifier's stages and protection circuits.
Description of the tone amplifier circuit and components.
Procedure for adjusting the power meter range.
List of various capacitors used in the amplifier.
List of various resistors used in the amplifier.
List of semiconductor components like transistors and diodes.
List of potentiometers and trimmers used for controls.
List of components related to volume, balance, and switch functions.
List of various other parts including hardware and fixtures.
List of components specific to the power supply unit.
List of components for the power amplifier section.
List of components for the preamplifier section.
List of components for the meter amplifier section.
List of components for the presence control section.
List of components for the switch unit.
Diagrams and substitution list for the power supply unit.
Diagrams and substitution list for the power amplifier unit.
Diagrams and substitution list for the presence unit.
Diagrams and substitution list for the meter amplifier unit.
Diagrams and substitution list for the preamplifier unit.
Diagrams and substitution list for the switch unit.
List of substitute parts for inductors.
Technical specifications for the power amplifier stage.
Technical specifications for the preamplifier stage.
General specifications including power, dimension, and weight.
To Next Page
