Need help?Do you have a question about the Kenwood KA-9100 and is the answer not in the manual?
General| Power Output | 90 watts per channel into 8Ω (stereo) |
|---|---|
| Damping Factor | 50 |
| Speaker Load Impedance | 4Ω to 16Ω |
| Input Sensitivity | 150mV (line) |
| Signal to Noise Ratio | 100dB (line) |
| Channel Separation | 60dB |
Visual identification of external components and connections.
Overview of internal component layout and major assemblies.
Procedures for dismantling power supply, diode, power pack, and control units.
Explanation of equalizer and flat amplifier circuit designs.
Description of tone, filter, and loudness control circuits.
Details on power supply design and protection mechanisms.
Explanation of power amplifier and DC amplifier designs.
Functional block and level diagrams of signal paths.
Visual circuit diagrams for power supply, control, and amplifier.
Part variations based on geographical destinations.
Comprehensive list of all components with part numbers.
Procedure to set the amplifier's DC center voltage.
Procedure to calibrate the power output meter.
Performance metrics for the power amplifier section.
Performance metrics for the pre-amplifier section.
To Next Page
