How to adjust the output level on a Kenwood KAC-M5014?
If the output level of your Kenwood Amplifier is too small or too large, the input sensitivity adjusting control may not be set correctly. Adjust the control to the correct position.
What to do if my Kenwood KAC-M5014 has no sound and a blown fuse?
If your Kenwood Amplifier has no sound, especially from one side, and you suspect a blown fuse, here's what to check: * **Disconnected Cables:** Ensure all input and output cables are securely connected. * **Protection Circuit:** The protection circuit might be activated. Check the connections. * **Blown Fuse:** Replace the fuse, but consider lowering the volume to prevent recurrence. * **Shorted Speaker Cord:** Inspect the speaker cord for shorts. After fixing any shorts, replace the fuse.
Why is the sound quality bad on my Kenwood KAC-M5014 Amplifier?
If the sound quality from your Kenwood Amplifier is poor or distorted, consider these potential causes and solutions: * **Incorrect Speaker Wire Connections:** Ensure speaker wires are correctly connected, paying attention to the positive (+) and negative (-) terminals. * **Pinched Speaker Wire:** Check that no speaker wire is pinched by a screw or any part of the car body, and reconnect if necessary. * **Improper Switch Settings:** Verify that all switches are set correctly.
Key warnings to prevent injury, fire, and equipment damage during operation.
Explains the amplifier's protection features and when they are activated.
Step-by-step guide for installing the amplifier in a vehicle.
Details on power output, impedance, frequency response, and input sensitivity.
Information on operating voltage, current, dimensions, weight, and environmental resistance.
Adjusts the pre-output level from the head unit to the amplifier.
General| Frequency Response | 20Hz - 20kHz |
|---|---|
| Input Sensitivity | 0.2V - 5V |
| Speaker Level Input | Yes |
| Current Consumption | 15A |
| Power Output (2 Ohms) | 75W x 4 |
| Bridged Power Output | 150W x 2 (4 Ohms) |
| Total Harmonic Distortion | 0.05% |
| Crossover | Variable |
| Power Supply Voltage | 14.4V (11V - 16V allowable) |
| Dimensions | 215 x 53 x 170 mm |
| Power Output (RMS) | 50W x 4 |
To Next Page
