Need help?Do you have a question about the Kenwood KAC-622 and is the answer not in the manual?
Audio Output| max power output stereo | 60 W+60 W |
|---|---|
| max power output mono bridged | 130 W |
| power output stereo normal | 30 W+30 W |
| power output mono bridged | 80 W |
| output power stereo normal | 40 W+40 W |
Frequency and Sensitivity| frequency response | 4 Hz~65 kHz |
|---|---|
| signal to noise ratio | 100 dB |
| sensitivity at rated output 0.1 V | 0.1 V |
| sensitivity at rated output 5.0 V | 5.0 V |
General Specifications| operating voltage | 14.4 V (11~16 V allowable) |
|---|---|
| current consumption | 15 A |
| damping factor at 100 Hz | More than 100 |
Weight and Dimensions| dimensions | 203 x 48 x 140 mm |
|---|---|
| dimensions (in inches) | 8 x 1-7/8 x 5-1/2 in. |
| weight | 1.6 kg (3.5 lb) |
Critical warnings to prevent electrical shock, fire, and injury during unit operation.
Proper methods and materials for cleaning the amplifier's exterior surfaces.
Information regarding potential radio frequency interference and modifications.
How to adjust the input sensitivity for optimal system matching.
Setting the output mode to Stereo or Mono (Bridged).
Step-by-step guide for connecting power, ground, and speaker leads.
Key safety points for speaker wire connections, ground attachment, and fuse management.
Recommendations for mounting the amplifier in vehicle locations.
To Next Page
